100-101 CCNA Interconnecting Cisco Networking Devices 1 (ICND1) (Exam 13)

100-101 CCNA Interconnecting Cisco Networking Devices 1 (ICND1) (Exam 13)

created by Fisher BRink (@fisher) at Feb. 8, 2016
  • Refer to the output of the three router commands shown in the exhibit. A new techn...

  • The system LED is amber on a Cisco Catalyst 2950 series switch. What does this ind...

  • Refer to the exhibit. Host B has just been added to the network and must acquire a...

  • Examine the network diagram and router output shown in the exhibit. Users on the B...

  • After the shutdown command has been issued on the serial 0/0 interface, what will ...

  • Refer to the exhibitA host is connected to switch port fa0/3. The host and switch ...

  • Refer to the exhibitHostA cannot ping HostB. Assuming routing is properly configur...

  • What is the difference between the Cisco router IOS commands "show cdp neighbor" a...

  • Refer to the exhibitWhat two things can the technician detemine by successfully pi...

  • Refer to the exhibitWhy did the device return this message?

  • What is the purpose of flow control?

  • Refer to the exhibit

  • IPv6 unicast routing is running on the Corp router. Which of the following address...

  • A host sends a type of NDP message providing the MAC address that was requested.Wh...

  • Each field in an IPv6 address is how many bits long?

  • To enable OSPFv3, which of the following would you use?

  • What does the command routerA(config)#linecons0 allow you to perform next?

  • Which two statements describe the IP address (Choose two.)

Be the first to review
Login and Review
  • info
    Quiz Info
  • date_range
    Feb. 8, 2016, 3:30 a.m.
    20 questions
    6 completed
    3 takers

  • 100-101 CCNA Interconnecting Cisco Networking Devices 1 (ICND1) (Exam 13) QR code