200-120 CCNA Cisco Certified Network Associate CCNA (803) (Exam 28)

200-120 CCNA Cisco Certified Network Associate CCNA (803) (Exam 28)

created by Fisher BRink (@fisher) at Feb. 8, 2016
  • When running OSPF, what would cause router A not to form an adjacency with router B?

  • Refer to the exhibit. Based on the exhibited routing table, how will packets from ...

  • Refer to the exhibit, when running EIGRP what is required for R1 to exchange routi...

  • Which type of EIGRP route entry describes a feasible successor?

  • Refer to the exhibit. The company uses EIGRP as the routing protocol. What path wi...

  • Which two commands correctly verily whether port security has been configured on p...

  • Refer to the exhibit. A junior network administrator was given the task of configu...

  • A network administrator needs to configure port security on a switch. Which two st...

  • Which command would you use on a Cisco router to verify the Layer 3 path to a host?

  • What is the purpose of the inverse ARP?

  • Refer to the exhibit. For what two reasons has the router loaded its IOS image fro...

  • Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down....

  • How is an EUI-64 format interface ID created from a 48-bit MAC address?

  • Refer to the exhibit. A network technician is asked to design a small network with...

  • Refer to the exhibit:

  • Refer to the exhibit:Assuming that the entire network topology is shown, what is t...

  • Two routers named Atlanta and Brevard are connected by their serial interfaces as ...

  • Refer to the exhibit. A network administrator configures a new router and enters t...

  • Which IPv6 address is valid?

  • Which two are features of IPv6? (Choose two)

Be the first to review
Login and Review
  • info
    Quiz Info
  • date_range
    Feb. 8, 2016, 3:30 a.m.
    20 questions
    0 completed
    0 takers

  • 200-120 CCNA Cisco Certified Network Associate CCNA (803) (Exam 28) QR code