4A0-110 Advanced Troubleshooting (Exam 1)

4A0-110 Advanced Troubleshooting (Exam 1)

created by Fisher BRink (@fisher) at Feb. 8, 2016
  • A CSPF LSP with no bandwidth requirement is established from Node 1 (10.10.1.1) to...

  • Which one of the following CLI can be used to view all management VPLS configured ...

  • Based on the configuration below, which statement best describes the reason why VP...

  • Due to same VPLS mis-configuration, traffic (e.g.ping) is not work between PC1 and...

  • Node 1 and Node 2 are directly connected running LDP. The system ip address of Nod...

  • A spoke-sdp terminated IES configured on Node 3 is down due on SDP serviceMTUMisma...

  • If a router needs to support services offering of 1514 byte service payload over P...

  • The mesh-sdp binding for a VPLS configured on Node 1 is down with an error service...

  • What are the possible logging destinations supported on the Alcatel 7x50?

  • Which command is used to view alarms of all severity levels on the Alcatel 7x50?

  • Which files have to exist on Compact Flash 3 during system initialization on the A...

  • Which command should be used to enable automatic synchronization for all software ...

  • A policy is configured to redistribute four active static routes into ISIS. No ISI...

  • An operator has entered the following CLI commands to configured redistribution of...

  • Which command can be used to view all interfaces configured under VPRN 300?

  • Node 1 receives some VPRN routes from Node 2, but Node 2 is not receiveing any VPR...

  • VPRN 300 is confiugred on Node 3 and Node 4 with LDP as the transport. No VPN rout...

  • Based on the following MP-BGP update packet, what is the export route-target of pe...

  • VPRN 300 is configured on Node 4. BGP is being used as the PE-CE routing protocol....

  • VPRN 300 is configured between Node 3 and Node 4. Node 4 receives VPN routes from ...

Be the first to review
Login and Review