4A0-110 Advanced Troubleshooting (Exam 2)

4A0-110 Advanced Troubleshooting (Exam 2)

created by Fisher BRink (@fisher) at Feb. 8, 2016
  • VPRN 300 is configured on Node 3 and Node 4 with LDP and MP-BGP. No route can be f...

  • Which one of the following routes should be the best BGP route according to the Al...

  • Refer to the diagram below, what encapsulation type and VLAN tag are required at p...

  • Two routers are physically connected to each other over Ethernet port 1/1/1. Revie...

  • Which of the following debug statements can be used to troubleshoot if the OSPF ad...

  • Based on the following configuration, which of the following statements are true? ...

  • Two routers are physically connected running ISIS. ISIS L2 adjacency is up and run...

  • Two routers are physically connected to each other with ISIS configured. No ISIS a...

  • L1 ISIS adjacency is up between two routers (Node-1 and Node-2) with MD5 authentic...

  • What are the typical RIP related issues found during troubleshooting?

  • Two direct connected routers are running RIPv2, neighbors are up but there is no r...

  • Node A has an active BGP route 10.1.1.1 in its routing table, but the same route i...

  • The LDP session is not down between Node-1 and Node-2. Based on the following conf...

  • A SDP is created on Node-2 with the far end address set to Node-3. The SDP stays d...

  • Based on the show display below, what should be done to further trouble the LSP pr...

  • Based on the following CLI Output, why is the path toPod3-loose down?

  • LSP toNode3 is configured on Node1, all hops configured in the lsp path and lsp de...

  • What MPLS tunnel label(s) will be used in the data packet traveling on LSP toR4 FR...

  • A LSP is configured with one primary path and one secondary path as below. What co...

Be the first to review
Login and Review